Safety instructions and reading help
IX
1070 072 143-101
Safety instructions
DANGER 0.1
Danger to persons and equipment!
Test every new program before operating the system!
CAUTION 0.2
Danger to the module!
Do not insert or remove the module when the control is switched on!
This can destroy the module. Switch off or remove the power supply
module of the control, external power supply and signal voltage before
inserting or removing the module!
CAUTION 0.3
Danger to the module!
All ESD protection measures must be observed when using the mo
dule! Avoid electrostatic discharges!
Observe the following protective measures for electrostatically endan
gered modules! (EEM)!
D The employees responsible for the storage, transport and handling
must be trained in ESD protection.
D EEMs must be stored and transported in the protective packaging
specified.
D EEMs may basically only be handled at special ESD work places set
up specifically for this purpose.
D Employees, work surfaces and all devices and tools, which could
come into contact with EEMs must be same potential (e.g. earthed).
D Wear an approved earthing strap around your wrist. The grounding
bracelet must be connected via a cable with integrated 1 M7resis
tance with the work surface.
D EEMs may on no account come into contact with chargeable ob
jects, these include most plastics.
D When inserting EEMs into devices and removing them, the power
source of the device must be switched off.
. These operating instructions apply to the following versions:
ZS400:
Firmware: 101
Hardware: Daughter board version: 0
Basic PCB version: 0
!
To Next Page
Loading...
