Bosch D7212GV3 - Page 65

D7212GV3 | Program Entry Guide | 2.0 Panel and Area Wide Parameters EN | 65
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
L## Del User
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
19 Delete User [COMMAND][5][3]
Delete users.
Although an individual user (001 through
099) can be deleted separately, use
caution with this function. User
passcodes, tokens or cards cannot be
deleted individually within a group. (For
example, User 001 has three additional
sub-users that use the same authority
levels for that group.) When dealing with
an individual user, change that user’s
token or passcode so that other users in
the group do not need to be added again.
L## Extend Close
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
20 Extend Close [COMMAND][5][1]
Change the closing time in the area where the
function is entered.
L## View Log
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
21 View Log
(Menu function
only)
View all panel-wide events in the control panel’s
memory log.
L## Print Log
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
22 Print Event Log
(Menu function
only)
Print all panel-wide events from the log to the printer
in the area where the user is executing this function.
This item can also be accessed using the
Service Menu ([9][9][ENT]).
L## User Cmd 7
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
23 User Command 7 [COMMAND][7]
This command can be used in Function Menu.
Generate the alarm programmed at COMMAND 7 in
the POINTS > Command 7 / Command 9 section..
L## User Cmd 9
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
24 User Command 9 [COMMAND][9]
This command can be used in Function Menu.
Generate the alarm programmed at COMMAND 9 in
the POINTS > Command 7 / Command 9 section..
L## Bypass a Point
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
25 Bypass a Point [COMMAND][0]
Bypass points with this authority level
L## Unbypass a Point
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
26 Unbypass a Point [COMMAND][0][0]
Unbypass points with this authority level.
L## Reset Sensors
Default: Refer to the program record sheet
Selection: - or E
Function
No.
Function Name
Alternate
Keystroke
27 Reset Sensors [COMMAND][4][7]
Reset sensors with this authority level.