D7212GV3 | Program Entry Guide | 6.0 AUXPARM EN | 115
Bosch Security Systems, Inc. | 10/11 | F01U170808-02
Figure 7: COMMAND 43 Flow Chart (D1260)
ALLOW ANSWER ?
COMMAND 43
RPS VIA PHONE ?
NEXT
NEXT
ENT
USE PORT ##### ?
NEXT
NEXT
RPS CONNECTING
ENT
RPS CONNECTING
ENT
(or ringing)
RPS VIA NETWORK?
NEXT
ENTER PORT NUM ?
##### ENT
ENT
Idle text
ESC
ESC
Idle text
ENTER PORT #####
ENT
RPS IP Address #
Default: 0.0.0.0
Selection: 0.0.0.0 to 255.255.255.255
0 to 255 There are four numbers for an IP
address. Leading zeros are not
required.
This prompt contains the IP address for RPS.
An IP address has four fields. Each field has a range
of 0 to 255. For example, an IP address is expressed
as 110.227.64.190. Contact your network
administrator to determine the IP address to which
the RPS computer is connected.
Refer to Keypad Programming of RPS IP Address #
and RPS PortNumber on page 116.
To Next Page
Loading...
