D8125 | Installation and Operation Guide | 4.0 Installation
Bosch Security Systems B.V. | 2020.04 |F01U036298-15
4.3.6 POPIT Displays
The status of each POPIT Module is transmitted to
the D8112G1/G2 control panel. The status is
recorded and held in the D8112G1/G2 memory buffer
until the system is armed and the exit delay time has
expired. The D1252A Keypad displays both the
current status and the event memory with a special
code.
4.3.6.1 Alarm Condition Displays
When an event occurs in the system (an open or
shorted loop) that the D8112G1/G2 interprets as an
alarm, the system initiates an alarm response, and the
D1252A sequences through the following displays:
4.3.6.2 Fault Condition Displays
When a loop fault occurs, the following displays can
appear on the D1252A (rows of stars separate
displays pertaining to individual points of protection):
4.3.6.3 Trouble Condition Displays
When a loop trouble occurs, the following displays
can appear on the D1252A (rows of stars separate
displays pertaining to individual points of protection):
To Next Page
Loading...
