D8125 | Installation and Operation Guide | 4.0 Installation
Bosch Security Systems B.V. | 2020.04 |F01U036298-15
4.3.5 POPIT Labels
Four sets of POPIT I.D. labels are provided with each POPEX Module. Each set is associated with either POPEX
#1 (PX 1) or POPEX #2 (PX 2), and with either the horizontal or vertical mode. In every POPEX/POPIT
installation, at least two sets of these labels are NOT used. For example, when installing a vertical mode
ZONEX system, all horizontal mode labels should be discarded. If the ZONEX system uses only one POPEX
Module, discard all the POPEX #2 labels.
Do NOT mix the horizontal and vertical
labels. The system can be programmed for
only one mode. Do NOT use both types of
labels in the same ZONEX system. A label
should be attached to each POPIT Module
when the switches are set, thereby
preventing duplicate switch settings. Do
NOT place labels on POPIT covers, attach
them directly to the circuit board. This
will help to prevent points from being
labeled or set incorrectly.
Here is an example of a POPIT display:
When an event occurs, the POPIT sends a signal to the control panel via the POPEX Module. The D8112G1/G2
decodes the event signal, displays an event status code, and initiates the appropriate system response. The
D1252A Keypad can be programmed to display two types of information: programmable and standard.
Instructions for programming D1252A Keypad displays are found in Program Items 105 through 120 in the
Omegalarm D8112:MAIN Program Entry Guide and the Omegalarm D8112:PTEXT Program Entry Guide.
To Next Page
Loading...
