EasyManuals Logo

Bosch rexroth A4VSO 10 Series User Manual

Bosch rexroth A4VSO 10 Series
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #104 background imageLoading...
Page #104 background image
BoschRexrothAG, RE 92050-01-X-B2/2019-08-23
28 A4VSO Series 10, 11 and 30 | Axial piston variable pump
Dimensions, size 500
Dimensions [mm]
Parallel keyed shaft DIN6885 Splined shaft DIN5480
P ‒ Ø80 AS 22×14×125 Z ‒ W80×3×25×9g
3
42
130
125
180
ø80
M20
1)2)3)
-0.2
+0.018
+0.002
Shaft key width 22
140
42
90
M20
1)2)3)
Ports Standard Size
3)
p
max abs
[bar]
4)
State
9)
B Working port (high-pressure series)
Fastening thread
SAE J518
6)
DIN 13
2 in
M20 × 2; 25 deep
400 O
B1 2. Working port (high-pressure series)
Fastening thread
SAE J518
6)
DIN 13
2 in
M20 × 2; 25 deep
400 X
8)
S Suction port SAE J518
6)
DIN 13
5 in
M16 × 2.5; 24 deep
30 O
K
1
, K
2
Flushing port DIN 3852
5)
M48 × 2; 22 deep 2 X
T Fluid drain DIN 3852
5)
M48 × 2; 22 deep 2 X
M
B
Measuring pressure B DIN 3852
5)
M18 × 1.5; 12 deep 400 X
M
S
Measuring pressure S DIN 3852
5)
M18 × 1.5; 12 deep 30 X
R(L) Fluid filling and air bleeding
(drain port)
DIN 3852
5)
M48 × 2; 22 deep 2 O
U Flushing port DIN 3852
5)
M18 × 1.5; 12 deep 5 X
7)
M
1
, M
2
Control pressure measuring DIN 3852
5)
see datasheetof
controlunits
400 X
1) Center bore according to DIN332
2) Thread according toDIN13
3) Observe the instructions in Part I (product-specific and general
instructions) concerning the maximum tightening torques.
4) Depending onthe application, momentary pressure peaks can occur.
Keep this inmind when selecting measuring devices and fittings.
5) The countersink may bedeeper than specified inthe standard.
6) Metric fastening thread isadeviation from standard.
7) For above-reservoir installation and for all installation positions
with "drive shaft up" a bearing flushing must be installed.
8) Plugged and high-pressure-proof with flange plate. Depending on
application, B and/or B
1
must be connected. The unused port
mustbe plugged with a flange plate.
9) O=Must beconnected (comes plugged)
X=Plugged (in normal operation)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch rexroth A4VSO 10 Series and is the answer not in the manual?

Bosch rexroth A4VSO 10 Series Specifications

General IconGeneral
BrandBosch
Modelrexroth A4VSO 10 Series
CategoryWater Pump
LanguageEnglish

Related product manuals