Bosch Rexroth CS660 - Troubleshooting Error Messages

13/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
STEP 1:
Ensure system safe to run
Make sure the Conveyor
and Gate cylinder has
been correctly set up and
calibrated
Start to proceed
STEP 2:
Continue if you have
a container ready and
sufficient material
always above the gate
opening throughout
the calibration process
Continue to next step
Stop to abort
STEP 3:
Controller
automatically move
the gate to position 1
Continue to next step
Stop to abort
STEP 4:
Recommend to discharge
minimum 100kg or 220lbs
material (more for better
resolution)
Enter weight of the
material collected
Continue to next step
Stop to abort