Bosch RTM 430 - Read and Set Parameters

60
6. Service menue for RTM 430
6.1 Read and set parameters
6.1.1 Date and time
The Service menu contains the following functions:
– Read and set parameters (Chapter 6.1)
– Read and set service-parameters (Chapter 6.2)
– Test functions (Chapter 6.3)
– Read measurement values (Chapter 6.4)
– Read errors (Chapter 6.5)
– Set Mode of RTM (Chapter 6.6)
– Reset RTM (Chapter 6.7)
– Service-program settings (Chapter 6.8)
– Store settings of RTM (Chapter 6.9)
– Configure RTM from a file (Chapter 6.10)
– Program RTM Firmware (Download) (Chapter 6.11)
The following keys can be used to choose the menus:
– Keys ↑ ↓ or
– entering the number in front of the menu item, e.g. 7 = Reset or
– the initial letter of the menu, e.g. R = Reset or
– choosing the menus directly with the mouse.
The following parameters can be set:
– Date and time (6.1.1)
– Date of last service (6.1.2)
– Linearity control (6.1.3)
The date and time can be set in this menu
You can choose or change the parameters with keys ↑ or ↓.
The chosen menu can be opened with key BLANK (space bar).
i If setting is not possible, you must activate the write enable function for date and time
in the Read and set service-parameters menu (Chapter 6.2.1).