Bosch RTM 430 - Date of Last Service

62
6.1.2 Date of last service
6.1.3 Value for linearity control
This menu is used to confirm service. After you confirm service, the timer (service interval)
set in the Read and set service-parameters menu is reset.
When entering the new service date with key BLANK (space bar), the old date is deleted
and the current date is set.
If a calibration stick is lost or is defective, you can a new calibration stick value in this
menu.
This menu is used to delete the value of the calibration stick entered in the RTM. The new
calibration stick value is entered when you then carry out the subsequent linearity control
procedure.