Bosch Therm 6000 S - Registration of Remote Control; Remote Control Operation

6 720 800 095 (2014/05) Therm 6000S
12 | Operating instructions
4.6 Registration of remote control (accessory no 7
709 003 756)
Only a qualied technician is allowed to install the additional
PCB that is supplied with the remote. Only after installation of
PCB the registration can be made.
The registration of the remote control must be done near the
appliance.
Hot water tap closed.
Turn OFF the appliance (Fig. 4, [1]).
 Press and hold the programming key (Fig. 4, [3]), press ON/
OFF button (Fig. 4, [1]) to connect the appliance.
Release programming key only when LCD displays “188”
The LCD displays the signal "P2".
 Press key , until it displays t
he signal "P3".
 Press programming key again for about 1 second.
LCD panel displays one number and one rotating digit.
The number represents the remote control which is to be
registered, the rst remote control will be registered with
number “0”, the second with number “1” and so on.
 Test the remote control in front of the electronic box by
simultaneously pressing the and control keys.
Fig. 15 Activate new control
 Press both keys until the LCD panel stops ashing and
shows the indication “00”.
 Press ON/OFF button (Fig. 4, [1]) to disconnect the
appliance .
Remote control is now deactivated.
4.7 Remote control operation (accessory no 7 709
003 756)
This appliance fullls European directive requirements 1999/
5/CEE (R&TTE) and correspo
nds to the specications
described in the cor-responding CE certicate of proof.
 Press buttons and in order to reach requested
temperature.
Fig. 16 Remote control (temperature selection)
Batteries replacement
 Remove the 2 screw from the remote control back.
 Open the cover.
 Remove the old batteries and correctly place the new ones.
 Close the remote control assuring that both screws are
tighten screwed.
Precautions when using the batteries
• Do not dispose of batteries as domestic waste. Take them to
appropriate collecting places for recycling.
• Do not insert at batteries.
• Only use the type of batteries indicated.
Press the ON/OFF button to turn ON the
remote control and it’s ready to work.
NOTE: up to 6 remote controls can be
programmed for one single water heater,
each with a range distance of 30m.
CAUTION:
 Remote control is not a toy - do not allow
children to play with the remote control
unit.
CAUTION:
 remote control can be used under the
shower , however, it’s immersion
must not be forced .