6 720 800 095 (2014/05) Therm 6000S
24 | Electrical connection
7 Electrical connection
All regulation, verication and safety mechanisms have been
rigorously tested in the factory and are ready for use.
7.1 Connection
Connect the feed cable to an earthed power point.
7.2 Power cable
The appliance is provided with a labelled power cord and
earthed mains plug.
Fig. 38 Power cable connections
7.3 Position of the fuses in control unit
To check fuses, proceed as follows;
Remove the front cover, see Fig. 23.
Remove the three screws from the control unit (Fig. 39 and
Fig. 40, [1]).
Fig. 39
Remove the six screws from the back cover of the control
unit, see Fig. 40, [2].
DANGER: Risk of electric shock!
Always disconnect the power supply to
the appliance at the mains before
carrying out any work on the electrical
systems and components.
CAUTION: Fuse protection!
The appliance should have an
independent connection to the electricity
mains, protected by a dierential 30 mA
switch and be earthed. In areas subject to
frequent storms, a storm protector
should be installed.
The electrical connection should be
according to current regulations regarding
domestic electrical installations.
An earth connection is absolutely
essential.
If the power cable gets damaged it must be
replaced by a genuine spare part.
To Next Page
Loading...
