Bosch Therm 6000 S - Installation Instructions; Factory Regulations; Measuring Gas Pressure

6 720 800 095 (2014/05) Therm 6000S
26 | Installation instructions
8 Installation instructions
8.1 Factory regulations
Natural gas
Heaters designed for Natural gas H (G 20) are factory sealed for
delivery after the values on the characteristics panel have been
checked.
Liquid gas
Butane heaters (G30) are factory sealed for delivery after the
values on the characteristics panel have been checked.
8.2 Measuring gas pressure
Conrm gas pressure after installation.
Connecting manometer
 Shut o gas supply.
 Remove the front cover  Fig. 23 .
 Loosen screw inside left test point tting (do not remove)
and connect manometer tube to test point.
Fig. 41 Gas pressure test port (left tapping)
Static Pressure Test
 Turn gas supply back on.
 Record static gas pressure reading in Table 7 .
Operating Pressure Test
 Press ON/OFF button
to turn o the appliance.
Sealed parts must not be interfered with.
Heaters should not be ignited when the
connections pressure is less than 1,5 kPa
more than 2,5 kPa.
DANGER:
 The following operations must be
carried out by a qualied technician.
Static Gas Pressure Reading
Pressure: ___________________ Date: ___________
Operating Gas Pressure Reading
Pressure: ___________________ Date: ___________
Table 7