Bosch Therm 6000 S - Program Button; Priority Function; Purge the Appliance

6 720 800 095 (2014/05)Therm 6000S
Operating instructions | 13
4.8 Program button
Program button can be used/programmed in the appliance and
in the remote control.
Programming "Program" function
Fig. 17 "Program" key
 Press buttons and to select temperature to
be memorized.
 Press "Program" button for 3 seconds to save temperature.
The temperature is saved on "Program" when the LCD panel
stops blinking.
Using "Program" function
In order to select memorized temperature:
 Press "Program" key.
LCD shows pre-memorized temperature, which is now the
selected hot water temperature.
4.9 "Priority" function
The appliance does not have a designated default priority.
Priority is attributed when the rst user selects a temperature
(see chapter 4.4).
The following symbol appea
rs for other users .
The priority user may change the initial selection at any time.
Non-priority users cannot change the selection made by the
priority user.
The system resets priority function 5 minutes after last water
demand, returning to the initial state.
To select priority
Any user may select temperature selection priority in the
following manner:
 Press one of the selection keys or for
5 seconds.
4.10 Purge the appliance
If there is a risk of freezing, proceed as follows:
 Close the cold water valve of the water heater.
 Open hot water taps to drain the water heater.
 Remove all the water contained inside of the appliance.
Each remote control program button can
be programmed with dierent temperature
values according with the user needs. A
temperature value can be programmed in
the remote control and another value in the
appliance.
PRIORITY is a function to prevents the user
from accidentally altering the water
temperature selected by another user.
Program
6720608920-32.1AL
Priority cannot be selected when the
appliance is working.
CAUTION:
 The non accomplishment of the purgative
of the appliance whenever the freezing
risk exists, it can damage components of
the appliance.
If the appliance is installed in places where
freezing risk exists the accessory anti-
freezing should be used, cod. 7 709 003
709.