Troubleshooting NL
Malfunction Cause and Troubleshooting
Loud noise during Device feet are not fixed.
▶ Secure the device feet. Setting the appli-
raat
centrifugation.
Transport protections have not been removed.
▶ Remove transport locks
Clapping, clattering
in the pump.
A foreign object has entered the pump.
▶ → "
Cleaning the drain pump", page 42
Slurping, rhythmic
suction sound.
Pump is active, the water is being pumped out.
▶ No error - normal operating noise.
wrinkling. Spin speed is too high.
▶ For the next wash, set a lower spin
speed in.
The load quantity is too high.
▶ During the next wash, reduce the load
amount of.
The wrong program has been selected for the type of
fabric.
▶ Select a suitable program for the type of fabric.
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
Low spin speed is set.
▶ For the next wash, set a higher spin
speed in.
▶ Start the program Centrifuge .
is activated.
▶ Select a suitable program for the type of fabric.
Drain pipe or water drain hose is clogged.
▶ Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶ Make sure that the drain pipe and water drain
feed hose is not kinked or pinched.
The unbalance detection system has aborted the spin
due to uneven distribution of the laundry.
▶ Redistribute the laundry in the drum.
Remark: If possible, place large and small items of
laundry together in the drum. Laundry of different
sizes is more evenly distributed when spinning.
▶ Start the program Centrifuge .
53
To Next Page
Loading...
