Connecting
the
system to
power
)
Note:
Bose recommends using a quality surge suppressor on all electronics equipment.
Voltage variations and spikes can damage electronic components
in
any system. A quality
suppressor can eliminate the vast majority
of
failures attributed
to
surges and may be pur-
chased
at
electronics stores.
Connect the
two
AC power (mains) cords
in
the following order:
1. Plug the small end
of
the Acoustimass® module power cord into the
AC
power jack on
the connector panel
of
the Acoustimass module (Figure 14).
2. Plug the other end
of
the power cord into
an
AC (mains) outlet.
3.
Turn the Acoustimass module POWER switch to on.
Figure
14
Power connection for
the Acoustimass module
Acoustimass module
connector panel
Power switch
I=ON
O=OFF
)
Note:
For dual voltage units (sold
in
certain areas), make sure the voltage setting
on
the bot-
tom
of
the media center power supply matches the local power rating (Figure 15). Check with
local electrical authorities
if
you are not sure
of
the appropriate power rating.
19
To Next Page
Loading...
