To
remove
a station
preset
Tune
to
the preset number you want to remove. Then follow the step below:
•
On
the remote control, press and hold the 0 number button until the message
PRESET:
<xx>
ERASED appears briefly on the media center display. The removal is then completed.
To
reassign a
preset
to a
different
station
1.
Tune
to
the station preferred.
2.
Using the remote control, press and hold the preset number button you want to reassign
to
that station.
Using
the
headphone
jack
For private listening, you can connect headphones to the jack located
on
the right side of the
media center as you face it.
J
Note:
Connecting headphones causes all main room speakers to be muted.
Using
the
sleep
timer
You
can set the sleep timer
to
turn off the
L1FESTYLE®
system automatically
in
10
to
90
minutes, depending on the time you select.
You
can do this
in
the Settings menu for any
source that
is
selected.
J
Note:
Ifyou are unfamiliar with use
of
the Settings menu, refer to "Making adjustments to a par-
ticular source]) on page 24.
In
the Settings menu on the media
center display or on the
TV
screen,
move around and make changes
by using the selection buttons.
To
set
the
timer
On
both the media center display and the TV on-screen menu, the same actions apply:
1.
Press the
Settings
button on the
L1FESTYLE®
remote
to
enter the source Settings menu.
2.
Move down to the Sleep Timer symbol, the last feature in the menu (Figure
3).
Figure 3
Sleep timer symbol
in
the
source Settings menu
J Note: Ifyou see a continuation arrow
at
the bottom
of
the menu, move to it
to
see the other
attributes that are
not
currently shown.
3.
Move right into the options list and up to the delay time you want, from 10 to 90 minutes.
J Note: Pressing the up arrow when you reach the 90-minute option turns the sleep timer
off.
4.
Press
Enter
to
confirm your selection.
5.
Press
Exit
or
Settings
on
the
L1FESTYLE®
remote control to leave the menu.
When the time you set elapses, the system, the TV (if it
is
on*), and the sleep timer will
all
turn
off automatically.
*For the TV
to
turn
off
automatically, the system must sense that it
is
on. This is contingent on
your use
of
the supplied
TV
sensor. For information on installing and testing the TV sensor,
refer
to
your
L1FESTYLE®
system Installation Guide.
17
To Next Page
Loading...
