Other
jacks
on
the
media
center
panel
Connecting
an
optional
antenna
extender
If your remote control does not communicate with the media center, the batteries may need
replacement
or
it may be out of transmission range.
To
extend the range, plug
an
antenna
extender, which may be purchased at an authorized
Bose®
dealer, into its connection on the
media center. See Figure 27 on page 30.
Connecting
the
optional
IR
emitter
cable
The
IR
(infrared) emitter cable
is
designed for optional use when a particular component does
not respond
to
L1FESTYLE®
system remote control commands. That
is,
the component is
connected
to
the media center, but placed where it cannot receive the
IR
signals from the
media center. The
IR
emitter can be placed next to one component only. See Figure 27 on
page 30.
To
use the emitter:
1.
Insert the 3.5 mm plug into the
IR
EMITIER jack on the media center panel.
2.
Place the flat side
of
the other end of the cable near the unresponsive component so that
the remote control signals reach that component.
)
Note:
Refer
to
"Controlling external sources"
in
your
LJFESTYL~
system Operating Guide for
details on how to program the
LJFESTYL~
system remote so that it works with your other
component.
3.
Confirm that
IR
signals now work to control that component. Move the emitter around, as
necessary,
to
find the best position.
4.
Use the double-sided tape enclosed with the emitter to affix it
in
the proper position.
)
Note:
If
you have questions, or need
to
obtain a replacement emitter, contact Bose customer
service. Refer
to
the Bose address list included with your system.
Data
port
for
system backups
Some systems will have a data port for future use. See Figure 27.
Serial
data
jack
This jack is for factory and service use only.
31
To Next Page
Loading...
