Installing
the
TV
on/off
sensor
The TV
on/off
sensor enables
the
system
to
automatically
switch
the TV on, as needed, when
another
video source (DVD, cable/satellite box, etc.) is selected. If you
choose
not
to
use
the
sensor,
you
need
to
turn on
your
TV separately. See Figure 19.
)
Note:
The TV on/off sensor is
not
included on
LlFESTYLPID
systems that use SCART
connectors.
With larger TVs you
may
want
a
second
person
to
help as you follow
the
steps
below:
1. Plug
the
sensor
cord
connector
into the TV SENSOR
jack
on
the
media center.
2.
Temporarily position the TV
on/off
sensor
on
the
back
of
your
TV as
shown
in
Figure 19.
3. Test
the
sensor and enable the feature. See
"Programming
your
L1FESTYLE@
system
remote
to
control
your
TV"
in
your
Operating Guide.
A. Turn
the
TV on. Press
the
System
button
on
the
L1FESTYLE®
system remote.
Access
VideolTV
power
status.
B. As
one
person
moves
the
sensor near
the
rear vent area
of
the
TV,
another
person
observes when TV Power Status changes from "TV
not
detected"
to
"TV ON".
C.
In
the
menu navigate
to
TV
Power
(directly above TV
Power
Status).
Change this from
"Manual"
to
"Automatic."
D.
You will need
to
select the TV brand and
device
code, as explained
in
the
guide.
)
Note:
00
NOT
use the mounting strip
to
permanently mount the sensor until you have tested
and
enabled this automatic feature as explained in the Operating Guide.
Figure
19
TV
on/off
sensor installed
on
your
TV
Rear
of TV
Mounting strip
for
attaching
the sensor
TV sensor
jack
)
Note:
For a projection
TV,
the bottom rear
of
the enclosure is the best location for mounting
the sensor. Front projectors that use a separate screen
may
need
to
be turned on
and
off
manually.
23
To Next Page
Loading...
