Using the
ADAPTiQ@
audio calibration
system
1.
Use the TV remote
to
turn on your television.
2.
Select the video input connected
to
the
L1FESTYLE®
system media center.
3.
Lift up the media center front cover and press the Open/Close button.
4.
Insert Setup Disc 1 into the tray (label side up) and press the Open/Close button again.
5.
On
the remote control, press the CD/DVD button.
6.
As the disc begins to play, listen carefully and follow the instructions.
You
will be
instructed when to play Disc
2.
7.
When Disc 2 indicates, connect the ADAPTiQ calibration headset to the AUX jacks on the
connection panel
of
the media center as shown below.
Figure
18
Using the AdaptiQ calibra-
tion headset
22
8.
Put on the headset so it rests above your ears for the greatest comfort during the
ADAPTiQ audio calibration process.
9.
Disc 2 will explain the procedure you are to follow.
Save the
headset
for
possible future use
When you have played both discs and followed their instructions, the installation
of
your
LlFESTYLE@
DVD
system
is
complete and its performance
is
tailored to the placement
of
your
system and your listening area.
You
may want to customize your system again if you move it to another room or significantly
change the arrangement
of
the room by relocating furniture, the speakers, or the
Acoustimass® module.
You
can repeat the steps
in
"Finishing the basic installation" on
page
21
at any time.
Keep the headset and discs together
in
their original carton and store them
in
a safe location.
To Next Page
Loading...
