Connecting
the
Acoustimass®
module
to
the
media
center
Connect the Acoustimass module
to
the media center with the audio input cable (Figure
11).
)
Note:
Be sure that each connector is fully inserted into each jack.
1.
You
may find it easier to insert the power adapter cord into the media center first.
Do
not
plug the other end into an AC (mains) power outlet until all connections are completed.
2.
Plug the small black multi-pin connector (flat side up) into the Speakers
jack
labeled
"Main"
on the
back
of
the media center.
3.
Insert the telephone-style RJ-45 connector on the other end
of
the audio input cable into
the Audio INPUT
jack
on the Acoustimass module. When properly inserted, it locks
in
place.
)
Note:
An antenna is built into the media center
power
cord; be sure
to
unwrap the
power
cord
for
the best remote control operation (Figure 11).
)
Note:
Refer
to
"Expanding your system
to
other rooms" on page
32
for information on con-
necting
a second room.
Figure 11
Acoustimass connection to
media center
Media center connector panel
Note:
When fully inserted into the jack, the connector
locks in place.
To
release the cable connector, press
the
tab.
A
CAUTION:
Do not place strain on the audio input cable, especially on the connection
to
the
Acoustimass module. Excessive strain on the cable
may
cause damage
to
the connection
at
the Acoustimass module. When disconnecting the cable from the Acoustimass module, be
sure to press the tab on the connector.
15
To Next Page
Loading...
