4.
If you have not plugged the small round connector
of
the media center power supply
cable into the
DC
POWER jack on the media center connection panel,
do
so now
(Figure
15).
5.
Insert the power supply cord connector into the power supply and plug the cord into
an
AC (mains) outlet.
Figure
15
Power connection for the
media center
Media center power supply
Be sure the power supply cord
is fully extended;
it
serves as the
remote control antenna.
DC
power jack
Installing
the
remote
control
batteries
Slide the battery compartment cover off
of
the back
of
the remote. Find the polarity markings
(+
and
-)
inside the compartment and install the four batteries accordingly (Figure
16).
Slide
the cover back on the remote and snap it closed.
J
Note:
00
notchange the settings
of
the factory-preset miniature switches. See your Operating
Guide for information on how
to
prevent conflicts with other LlFESTYLE® systems.
Figure
16
Remote control battery
installation
20
Four
(4)
AAA (lEC-LR3)
batteries
Battery
compartme~
cover
Replace all four batteries when the remote control stops operating or its range seems
reduced. Alkaline batteries are recommended.
Your remote control will need
to
be "taught"
to
control external components
of
your home
theater, including your TV See your Operating Guide for details.
To Next Page
Loading...
