Figure
8
Making the plug-in cable
connection
2. Insert the speaker plug
of
each cable fully into the
jack
on the rear
of
one
of
the five
speakers. The raised part on the plug slips into a notch at the
top
of
the jack.
3.
Connect
the RCA
connector
at the other end
of
each cable to the corresponding
jack
on
the Acoustimass@ module (Figure 10 on page 14).
• Blue connectors
go
into the matching left front, center, and right front jacks.
• Orange connectors
go
into the matching left surround and right surround jacks.
Making
the
two-wire
connections
for
cube
or
cube
array
speakers
;
Note:
The surround speaker cables are joined together for your convenience, providing an
easy-to-use cable for connecting the surround speakers.
To
run the cables
in
different direc-
tions from the Acoustimass module, simply pull apart the cables
as
needed.
;
Note:
To
lengthen the speaker cables, use heavy-duty RCA extension cables,
or
splice
in
18-
gauge
or
thicker cord (connecting +
to
+
and
- to
-).
To
purchase extension cables, see
your
dealer
or
electronics store,
or
call
Bose®
customer service. Refer to the Bose address list
included with
your
system.
In
Figure
9,
the wire marked with a red collar is positive
(+)
and the plain one is negative (-).
These wires match the positive (red) and negative (black) terminals on the
back
of
each
speaker.
1. Match the correct cable to the corresponding speaker location.
• Front speaker cables have blue connectors at one end, with L (left), R (right), or
C (center) molded into the connectors. A red collar on each
+ wire is labeled
LEFT,
RIGHT, or CENTER.
• Surround speaker cables have orange connectors at one end, with L (left) or R (right)
molded into the connectors. A red collar on each
+ wire is labeled
LEFT
or RIGHT.
13
To Next Page
Loading...
