Problem
What
to do
Radio does not work
•
Make sure antennas are connected properly.
•
Move AM antenna at least 20 inches (50 cm) from the media center.
•
Adjust antenna position to improve reception.
•
Make sure the
AM
antenna
is
in
an
upright position.
•
Move antennas farther from media center,
TV,
or other electronic equipment.
•
Select another station.
You
may be
in
an
area of weak signal coverage for some stations.
The disc does not play
•
After pressing the CO/OVO button, wait a few seconds before pressing
Play.
•
Make sure the disc
is
properly inserted (label side up).
•
Eject the disc and try loading it again.
•
The
CO
may be dirty. See "Cleaning discs"
on
page 40.
•
Try another CD. The CD may be defective or not compatible. See "Types of discs you can
play" on page
5.
FM
sound is distorted
•
Adjust antenna position to reduce interference.
FM
sound is noisy
•
Weak
FM
stations will produce static
in
the surround speakers. Select the 2-speaker mode
in
surround mode
in
the Settings menu to minimize noise. See "Tuner setting options (FM or
AM
radio)"
on
page 26.
Sound is distorted
·
Make sure speaker cables are not damaged and the connections are secure.
•
Reduce the output level from any external components connected
to
the media center.
No sound from
•
Check the connections.
TV,
CO/DVO, VCR,
•
Make sure that component
is
turned on.
orAUX
•
Refer to the component owner's manual.
U
FESTYLE®
remote
•
Make sure correct codes are set.
does not control
See "For TV control" on page 18.
your
TV,
VCR,
•
Make sure that the front of the media center
is
not obstructed. The
IR
emitter that sends
cable/satellite box,
commands to your external components
is
below the disc tray.
or other external
•
If you still cannot control your external components successfully, you may need to connect
component
the external IR emitter, included with your system, to the
IR
EMITTER jack
on
the rear
panel of the media center. See "Connecting the
optionallR
emitter cable"
in
your
L1FESTYLE®
system Installation Guide.
Your
TV
turns
•
Reposition the TV on/off sensor
on
the back of your
TV.
Or check the SCART connector if
on and off unexpectedly
you use one.
•
Verify that the TV on/off sensor
is
working properly by choosing TV Power Status under
Video
in
the System menu.
TV screen goes dark
•
Use the media center to check the Video Format and Progressive Scan settings, following
or image flips repeatedly
instructions
in
"Activating component or progressive scan connections" on page
11.
after making a change
- Video Format should be set
to
NTSC (U.S. standard) or
PAL
(European standard).
to a Video feature
in
- Make sure the Progressive Scan setting is Off, unless you have used a component
System settings
video connection and progressive scan
is
a feature of the TV
You
forgot
•
Enter the numbers 2673 as temporary password to access the parental controls. Then
your password
create a new password.
Contacting
customer
service
For additional help
in
solving problems, contact
Bose®
customer service. See the address
and phone number list included with your system.
42
To Next Page
Loading...
