BASIC SYSTEM CONNECTIONS
1
Connect
the
speaker
cables to
the
speakers
Front center
speaker
Front and rear
left, right
speakers
A.
Notice the marking on the red collar on the speaker
cable and match it
to
the speaker
in
that location:
• Front speaker cables are marked L (left), R (right),
and C (center).
• Rearspeaker cables are marked
LR
(left rear) and
RR
(right rear).
The cables for these speakers have wire ends that con-
nect
to
red and white connection terminals (Figure
5).
Connecting
array
speakers
~
Front center
~speaker
Front and rear
left, right
speakers
The speakers you have are one
of
the
two
types shown here. They differ
in
how the cables
connect
to
them.
Before you start, route the cables around your room.
To
make the rear speaker cables reach
each
of
the rear speakers, you can unzip the cables by simply pulling them apart.
Follow the instructions for the type
of
speakers you have.
A.
Notice the marking on each cable plug and match it
to
the speaker
in
that location:
• Front speaker cable plugs are marked L (left), R
(right), and C (center).
• Rear speaker cable plugs are marked
LR
(left rear)
and
RR
(right rear).
The cables for these speakers have a customized plug
that fits into the connector only one way (Figure
4).
Connecting
Jewel
Cube®
speakers
B.
Orient the plug with its small knob up, so the plug slips
easily into a notch on
top
of
the connector (Figure
4).
C.
Insert the plug fully into the connector on the rear
of
its
respective speaker. For example, the plug marked L
connects
to
the speaker at the left front
of
your room.
B.
Press the terminal tab
to
insert each wire into the
proper connector. Be sure
to
match the red-collared
wire
to
the red speaker connection terminal
to
maintain
proper
+ and - polarity.
Figure 4
Figure 5
Jewel Cube speaker connections
Wire label:
L,
R,
LR,
or
RR
Array speaker connections
Terminal tab
Plug label:
C
Knob
Plug label:
R,
L,
RR,
or
LR
Wire label: C
13
To Next Page
Loading...
