BASIC SYSTEM CONNECTIONS
4 Connect
the
VS-2 video enhancer
to
the
media
center
Figure 8
VS-2 connections to the
media center
16
To
complete this connection, you need the power supply and the V8-2 cable.
A.
Insert the Serial Data plug into the Serial Data connector.
B.
Insert the DC Power plug into the DC Power connector.
C.
Insert the Composite plug into the Composite Video OUT connector.
D.
Insert the S-Video plug into the S-Video OUT connector.
E.
Insert multi-pin plug into the
Media
Center
connector.
F.
Insert the DC Power plug into the DC POWER Out connector.
G.
Insert the
DC
power cord from the power supply into the
DC
POWER
In
connector on
the V8-2.
Note: Straighten the DC
power
cord
from the
power
supply to the VS-2
and
from the VS-2 to
the media center
as much as possible.
This
cord
is
used as the antenna for your
LIFESTYLE®
system remote control.
Media
center
rear panel
Power supply
DC
power cord
VS-2 end panel
O(;I-'QW[fl
MEDIACENTfR
......
VS-2
cable
To Next Page
Loading...
