BASIC SYSTEM CONNECTIONS
8
Connect
AM
and
FM
antennas
to
the
media
center
The supplied AM and
FM
antennas connect
to
the rear panel
of
the media center (Figure 12).
it..
CAUTION:
00
NOT
connect
your
television antenna cable to the FM antenna jack.
To
connect
the
FM
antenna
A.
Insert the plug on the
FM
dipole antenna lead into the FM antenna connector.
B.
Place the antenna as far from the media center and other components as possible.
C.
Spread out the antenna arms and change their orientation as needed
to
get the best
FM
reception.
Note:
The
FMjack (75 ohm)
may
be
used with an outdoor antenna. Before doing this, consult a
qualified installer. Follow all safety instructions supplied with the antenna.
To
connect
the
AM
antenna
A.
Insert the plug on the AM antenna lead into the
AM
antenna connector.
B.
Stand the loop antenna
on
the base or mount the antenna on a wall, following the
instructions enclosed with the AM antenna.
C.
Move the AM loop antenna at least 20
in
(50
cm) from the media center and at least 2
ft
(60
cm) from the Acoustimass® module.
When all connections are completed and you can turn on your system, you may need
to
experiment with the orientation of the loop antenna for optimum AM reception.
Note:
AM
reception can
be
adversely affected
by
a nearby television when it
is
on.
Turn
off
the
TV
for
best
AM
reception.
Figure
12
Media center antenna
connections
FM
dipole antenna lead
V
Media
center
rear panel
To
connect
to
cable
radio
Some cable
TV
providers make
FM
radio signals available through the cable service
to
your
home. Using a signal splitter, you may be able
to
feed the cable radio signals
to
the
FM
con-
nector on your media center. Contact your cable
TV
provider for assistance.
20
To Next Page
Loading...
