OPTIONAL CONNECTIONS AND ADDITIONS
Using
the
IR
emitter
Figure
20
IR
emitter connector
location
If a component does not respond
to
the
LIFESTYLE®
system remote control commands,
the
IR
(infrared) signals may not be reaching it. Try moving the component or media center
slightly
to
see if that improves the response.
If there is still a problem, connect the supplied
IR
emitter
to
establish a solid response while
setting your
LIFESTYLE®
remote
to
control this component.
You
may not need
to
use the
emitter after that. Or keep it connected, as needed, for use with one component.
Note:
For information on
how
to set the
LIFESTYL~
remote to control the
TV,
refer to your
Operating Guide.
To
connect
the
IR
emitter:
1.
Insert the plug into the IR
Emitter
connector on the media center connection
panel (Figure 20).
2. Place the other end
of
the cable near the component with the rounded surface
of
the
emitter facing the component.
3.
Operate the component
to
see if it responds
to
remote commands. Move the emitter
around, if necessary,
to
find the best position.
4.
Use the double-sided tape enclosed with the emitter
to
affix it
in
position near the
component.
IR
Emitter
Note:
To
purchase an add-on
IR
emitter for use with up to three components,
or
for replacement
of
the supplied emitter, contact
Bose®
Customer Service. Refer to the address list included
in
the
carton.
Using
a
remote
control
antenna
extender
If your system does not respond
to
remote control commands, but you know the remote
batteries are good, you may need
to
add
an
antenna extender
to
help the remote work within
its specified range.
To
contact Bose
to
purchase
an
extender, refer
to
the address list
included
in
the carton.
29
To Next Page
Loading...
