BASIC SYSTEM CONNECTIONS
9
Connect
the
system
to
power
Figure
13
Power connection for
the Acoustimass module
Figure
14
Power connection for the
media center
power
supply
To
complete this step, you need the
two
identical AC power cords, one for the Acoustimass®
module and the other for the power supply.
To
connect
power
to
the
Acoustimass module:
On the connector panel
of
the Acoustimass module, plug the appropriate end
of
one
AC power cord into the AC power jack (Figure 13). Insert the other end
of
the power cord into
an
AC (mains) outlet.
AC power jack
AC power cord
Note: Bose recommends using a high-quality surge suppressor on al/ electronics equipment.
Voltage variations
and
spikes can damage electronic components
in
any system
and
the resulting
damage
may
not
be
covered
by
the limited warranty. A quality suppressor can eliminate the vast
majority
of
failures attributed to surges
and
may
be
purchased
at
electronics stores.
To
connect
power
to
the
power
supply:
Plug the appropriate end
of
the AC power cord into power supply (Figure 13). Insert the other
end
of
the power cord into
an
AC (mains) outlet.
AC (mains)
outlet
~-----------~To
the
..........
......
media center
Power
supply
AC Power cord
Voltage selection switch location
(dual-voltage units only)
If
you
have
a dual-voltage
power
supply:
Before connecting power
to
the media center power supply, MAKE SURE the voltage selec-
tion switch on the bottom
of
the media center power supply matches the local power rating
(Figure 14). Check with local electrical authorities if you are not sure
of
the appropriate power
rating.
21
To Next Page
Loading...
