BASIC SYSTEM CONNECTIONS
7
Connect
audio source outputs
to
media
center
audio inputs
The media center has analog and digital audio inputs for your cable/satellite box, VCR,
TV,
and one other source. This step explains how
to
connect your sources using the analog audio
input connections (Figure 11).
Note:
To
make higher-quality audio connections, refer to "Using digital audio connections" on
page 27.
You
need
an
RCA stereo audio cable for each source
to
complete this step. One stereo audio
cable with red and white RCA plugs is supplied with your system.
Note:
Make sure the
VCR,
CBL-SAT,
and
AUX
audio input connections on the media center
match the corresponding
VCR,
CBL-SA
T,
and
AUX
video input connections on the VS-2.
A.
Plug one end
of
an
RCA stereo cable into the left and right audio output connectors
on the audio source. Match the white
p-Iug
to
the left
(L)
output and the red plug
to
the
right
(R)
output.
B.
Plug the other end
of
the cable into the left and right audio input connectors on the
media center. Match the white plug
to
the left
(L)
output and the red plug
to
the right
(R)
output.
Figure
11
Analog audio connections
AUX
c:::::::J
L::::::J
~
UDIOOUT
o
~:$
CBL.SAT
1=
c:=:J @ I
............ ............
~:OUT]
AUX
CBL-SAT VCR
VCR
I
OOOOgO
[I
III
c:::J
c:::Jc:::Jc:::Jc:::Jc:::J
L::::::J
c:::::::J
~
UDIOOUT
o
~;0
TV
19
To Next Page
Loading...
