25
7.0 LIMITER Button
The four output limiters each have the the
following parameters:
Limiter On/Off: Bypasses the limiter
Threshold: Sets the level at which the limiter
will activate. When the input signal exceeds the
threshold, the limiter will be activated. The lower
the threshold, the more sensitive the limiting will
be.
Ratio: The ratio of gain reduction.
For example: if the ratio is set to 4:1, it means
that for every 4dB the actual audio signal will
rise only 1dB over the threshold.
Attack: The time it takes the limiter to reach
gain reduction specified by the ratio parameter
when the signal is above the set threshold.
Release: Release is the time that the limiter
uses to release the gain reduction when the
signal exceeds the threshold.
Gain: Use the gain parameter to compensate
for unwanted gain reduction caused by heavy
limiting.
Pressing the LIMITER button provides access to
four independent output limiters that can protect
the loudspeakers from damage if an operator
overdrives the system. Use the Arrow UP and
Arrow DOWN buttons to navigate through the
parameters, and use the ENCODER wheel to
select parameter values.
To Next Page
Loading...
Need help?
General
