Bose PANARAY System

32
10.0 Optimizing Signal-to-Noise
Use the table below to match the PANARAY
®
system digital controller’s Output Range to your amplifier.
8. Select a speaker EQ preset on the PANARAY
system digital controller by pressing the
PRESET button and using the Encoder wheel
to select the desired speaker EQ preset.
9. Turn your amplifier On, and turn up each level
control until you reach the desired SPL.
These settings will automatically be retained.
retemaraPegnaRtuptuO ytivitisneStupnIreifilpmA
uBd2 V577.0nahtsselgnihtynarofesU
uBd8 V579.0otV577.0
uBd41 V9.3otV579.0
uBd02 V57.7otV9.3
:etoN ruoyhctamyltcaxetahtsgnittesoneraerehtfI
tahtgnittestsehgihehtkcip,ytivitisnestupnis'reifilpma
ehtesudnaytivitisnestupnireifilpmaruoytseraensi
ehtkcabelacsotlortnocLEVELTUPTUOs'rellortnoc
.tuptuollarevo
Set the PANARAY system digital controller out-
put range. First, press the UTILITY button.
Then press the Arrow DOWN button until you
see the following display:
Adjust this parameter with the Encoder wheel
to match your amplifier’s input sensitivity.
This setting will provide the optimum input level
for your amplifier.
Output Range
20dB (Pro)
Output Range
14dB (Consumer)