Boston Multi-DM - Specific Warnings to Observe

Multi-DM™ User Manual Section 3 - Safety Information
BMC Document Number: DOC-0009 Rev. 5.2 Page 4
3.2 Specific Warnings to Observe
The following warnings apply in a general sense throughout this document.
Additional warnings can be found at critical points in this document.
SHOCK HAZARD
Voltages up to 300V can be present on the deformable mirror (DM), packaging,
electrodes, cable, and electronics driver.
DO NOT come into contact with these items when the system is powered on.
DEFORMABLE MIRROR ESD DAMAGE
The DM is highly sensitive to electrostatic discharge.
Always handle the DM in an electrostatically sensitive environment
while wearing a Grounding Wrist Strap (shipped with system).
MULTI DRIVER ESD DAMAGE
The Multi Driver is highly sensitive to electrostatic discharge.
Always handle the Driver in an electrostatically sensitive environment
while wearing a Grounding Wrist Strap.
Avoid touching any electrical interconnections.
MULTI-DM HAS NO USER SERVICEABLE PARTS
Do not open or disassemble in any way.
Contact Boston Micromachines for any service required.
MULTI DRIVER HAS NO USER SERVICEABLE PARTS
Do not open or disassemble in any way.
Contact Boston Micromachines for any service required.