Multi-DM™ User Manual Section 5 - System Components Overview
BMC Document Number: DOC-0009 Rev. 5.2 Page 15
5.4 SDK and Demonstration Software
Along with the DM and Multi Driver, a USB flash drive is supplied
that includes the following files:
By default, the DM and Multi Driver system ships with an SDK and applications
for Microsoft Windows 64-bit operating systems.
A Linux SDK is also available, contact Boston Micromachines for details.
• DMSDK-Setup-<version number>.exe, a self-executing installation program
that installs the following components:
o Software drivers for programming the DM in the C or C++ programming
language.
o Software drivers for programming the DM on the MathWorks MATLAB
and National Instruments LabVIEW platforms.
o DMShapes, a graphical user interface application that can load a shape
from a Command Map file, set the entire DM to a particular value (piston),
or set actuators individually (poke) or sequentially (play).
o BMCLoadShape, a command line application that reads a shape from a
Command Map file and applies it to the DM.
o A full set of documentation in PDF and HTML format.
o Hardware drivers for the Multi Driver so that it will be recognized by Windows
when it is connected to the PC.
• The DM Profile file, a configuration file that is matched to
a unique DM and Driver combination.
• The DM Half Bias Flat Map file, a Command Map that drives
the Deformable Mirror surface to a plane.
• The User Manual for the DM (this document) in PDF format.
• A DM- and Driver-specific System Data Sheet file in PDF format.
This contains full system specifications, system test results,
command vs. deflection curves, and interferometric surface data.
For software installation instructions see Section 6, BMC SDK Software Installation.
To Next Page
Loading...