Multi-DM™ User Manual Section 5 - System Components Overview
BMC Document Number: DOC-0009 Rev. 5.2 Page 14
J1 through J4 connectors:
High voltages may be present.
Only make connections with the Multi Driver off.
DO NOT use the HV and GND connections unless specifically instructed
to do so by a Boston Micromachines technical representative.
High voltages may be present.
Only make connections with the Multi Driver off.
Table 5 - Rear Panel Adjustments
Amplifier Bias Current Limit Adjustment
Voltage Reference Adjustment (Range of Digital to Analog Converters)
VP Pot High Voltage Output Rail Adjustment (Maximum Voltage Supplied to DM)
DO NOT adjust the VB, VR, or VP controls unless specifically instructed
to do so by a Boston Micromachines technical representative.
To Next Page
Loading...