4
GENERAL SAFETY RECOMMENDATIONS
Safety informational callouts used in this manual include:
This emblem is used to warn against hazards and un-
safe practices which COULD result in severe injury or
death if proper procedures are not followed.
Safety for operators and ground personnel is of prime con-
cern. Always take the necessary precautions to ensure the
safety of others as well as yourself. To properly ensure
safety, the prime mover and winch MUST be operated with
care and concern by the operator of the equipment. The
operator MUST also have a thorough knowledge of the
machine’s performance capabilities.
1. Read and understand ALL warning tag information,
and become familiar with ALL controls BEFORE op-
erating the winch.
2. NEVER attempt to clean, oil or perform maintenance
on a machine with the engine or prime mover running,
unless instructed to do so in this manual.
3. NEVER operate the winch controls unless you are
properly positioned at the operator’s station, you are
sure ALL personnel are clear of the work area AND
you are properly trained in the operation of the winch.
4. Assure that personnel who are responsible for hand
signals are clearly visible and that the signals to be
used are thoroughly understood by all involved.
5. Ground personnel should stay in view of the operator
and clear of the winch drum. DO NOT allow ground
personnel near a winch line under tension. A safe dis-
tance of at least 1½ times the length of the outstretched
cable should be maintained.
6. On machines having hydraulically, mechanically and/
or cable controlled equipment or attachments, ensure
the equipment is blocked securely before servicing,
adjusting or repairing the winch. ALWAYS apply the
parking brakes before dismounting a vehicle.
7. Inspect the winch and rigging at the beginning of each
work shift. Defects should be corrected immediately.
DO NOT operate a defective winch.
8. Keep equipment in good operating condition. Perform
scheduled service and adjustments as defi ned in the
“Preventive Maintenance” section of this manual.
9. An equipment warm-up procedure is recommended for
all start-ups, and is essential at ambient temperatures
below +40°F (5°C). Refer to the “Warm-Up Procedure”
listed in the “Preventive Maintenance” section of this
manual.
10. The winches described in this manual are neither de-
signed nor intended for use or application to equip-
ment used in the lifting or moving of persons.
11. DO NOT exceed the maximum pressure, PSI (kPa), or
fl ow, GPM (LPM), stated in the winch specifi cations.
12. Operate at winch line speeds to match the job condi-
tions.
13. Protective gloves should be worn when handling wire
rope.
14. NEVER attempt to handle wire rope when the hook
end is not free. Keep all parts of body and clothing
clear of cable rollers, cable entry area of fairleads and
winch cable drum.
15. When winding wire rope on the cable drum, NEVER
attempt to maintain tension by allowing the wire rope
to slip through hands. ALWAYS use the “Hand-Over-
Hand” technique.
16. NEVER use wire rope with broken strands. Replace
damaged wire rope.
17. DO NOT weld on any part of the winch without ap-
proval of PACCAR Winch Division Engineering.
18. Use the recommended hydraulic oil and gear lubri-
cant.
19. Keep the hydraulic system clean and free of contami-
nation at all times.
CAUTION
This emblem is used to warn against potential or un-
safe practices which COULD result in injury and prod-
uct or property damage if proper procedures are not
followed.
Failure to obey the following safety recommendations
may result in property damage, injury, or death.
To Next Page
Loading...
