ENGLISH 9 / 77 CAP. 3 - SAFETY CONDITIONS
M
ULTIGAS
e
nsure the air change in every environment area or to carry out a periodical ventilation by
opening the environment areas. Use the tool away from heat sources or hot surfaces. The tool
has not to be used in explosion risk environments (potentially explosive atmospheres). Before
using it, put the tool on a levelled plane and secure position, blocking it with suitable wheel stops.
Do not expose the tool to direct sunrays, heat sources, rain and jets of water. Do not smoke close
to the equipment and during operations (keep at a distance of at least 1 m).
The work area must be monitored by the operator while the equipment is operating.
ATTENTION: the R134a and/or R1234yf refrigerant fumes/gases are heavier than air and can
gather on the floor or inside cavities/holes and cause choke by reducing the oxygen available for
breathing.
At high temperatures, the refrigerant breaks down releasing toxic and aggressive substances,
harmful for the operator and the environment.) Avoid inhaling the system coolants and oils. The
exposure can irritate eyes and the respiratory tract.
ELECTRICAL CONNECTION: Connect the power cord solely to a mains supply which conforms
with the ratings on the machine's nameplate (mounted on its side). Make sure the mains socket is
grounded.
Never use the service station with a defective power cord or a different one from that supplied
with the machine; if damaged, immediately have it replaced with an original spare or equivalent
by a Brain Bee S.p.A. service centre. Before opening the service station, extract completely the
supply cable from the plug, or you can get an electric shock.
Do not tamper with or bypass the safety equipment and settings.
Do not leave the machine powered up when not in use; shut off the power supply before leaving
the equipment unused for a long time. Do not forget that the tool (pressure tool) must always be
protected.
To Next Page
Loading...
