ENGLISH 13 / 77 CAP. 3 - SAFETY CONDITIONS
M
ULTIGAS
3.2 IMPORTANT SERVICE EQUIPMENT SAFETY INFORMATION
When using the tool, the following operations are not allowed as they might cause, under certain
circumstances, danger for persons and cause permanent damage to the tool itself.
- Do not remove or make unreadable labels, signs and/or dangers signs placed
on the tool and in the area nearby.
- Do not disable the unit's safety equipment.
- Use only fuses identical to the originals as specified on the nameplate; do not
tamper with or attempt to repair the fuses.
If the power supply is known or can be expected to vary beyond the limits
specified for the service equipment, immediately disconnect it.
- The electrical system to which the service equipment is connected must be
configured as provided by local legislation.
- Only operators or qualified staff instructed or certified for the tool maintenance
can open the tool. The equipment contains parts which can cause electrocution:
shut off power to the equipment before servicing/repairing it.
3.3 SAFETY DEVICES
MULTIGAS 8500 PLUS is equipped with the following safety devices:
SAFETY PRESSURE SWITCH: It stops the compressor in case of excessive
pressure.
SAFETY VALVE: The safety valve opens when the pressure inside the system
reaches a level higher than the fixed limits.
SWITCH: Switches the equipment off by interrupting the power supply. It is
advisable to pull the power cord plug out of the mains socket in any case
before starting maintenance work.
ANY TAMPERING WITH THE ABOVE-MENTIONED SAFETY DEVICES IS
PROHIBITED.
Failure to observe any of the above safety instructions voids the equipment's warranty.
To Next Page
Loading...