6.2 Damaged Equipment
Discontinue Use
If you discover a defect:
Steps
1. Switch the system off.
2. Disconnect the system from mains power.
3. Contact Brainlab support.
4. Place a notice such as “DO NOT USE” on the equipment to prevent inadvertent use.
Do not continue to use equipment that has been found to be defective during an
inspection. Using damaged equipment may cause patient injury.
Required Information
When you contact Brainlab support regarding a defect, you are asked for:
• System serial number on the Monitor Cart type plate
• Component serial number inscribed on the component (Monitor or Camera Cart or EM Base
Station or EM Field Generator)
• A description of the problem
Repair/Replacement
Brainlab support:
• Provides you with a cost estimate for repair or replacement
• Informs you when your system is expected to be operational again (usually within 48 hours)
Return Instructions
Refer to the System User Guide.
MAINTENANCE
Technical User Guide Rev. 1.1 Curve Dual Navigation Station Ver. 1.2 85
To Next Page
Loading...
