6
-
5
MAINTENANCE
6
ROUTINE MAINTENANCE
OPENING HOOD
1. The hood can be unlocked by pull-
ing the opening knob.
2. Slightly lift the hood with both
hands and the hood is automati-
cally lifted by the gas spring.
3. To close the hood, press its front
down slightly until a "click" sound
is heard.
4. After closing the hood, lift it to
check that the hood is securely
xed.
CHECKING AND REPLACING ENGINE OIL
CHECKING
Pull out the oil dipstick, clean it, and
then insert it into its original position.
Then, pull it out again and check if
the oil level is within the specified
range. If the oil level is too low, add
new oil so that the level is within the
allowable range.
To drain oil, remove the drain plug on
the bottom of the engine. Fill new en-
gine oil through the ller after install-
ing the drain plug. Change engine oil
periodically with proper engine oil ac-
cording to the temperature and oper-
ating condition.
(1) Opening knob (1) Oil dipstick (2) Oil inlet
REPLACING
(1) Drain plug
A42O601A A42O602A
A42O603A
First 50HR engine oil has to be
changed.
•
NOTE
To Next Page
Loading...
