5
-
6
Branson F36R(H)/F42R(H)
COLD START
1. When starting in cold weather, turn
the ignition switch to the "ON" po-
sition and then wait until the pre-
heat indicator is turned off.
2. For safe operation, turn the igni-
tion switch to the "START" position
with the clutch pedal depressed.
3. Repeat the above procedures until
the engine is operated smoothly.
4. Let the engine idle at 1,200 rpm to
warm up the engine up to the op-
erating temperature.
CAUTION
In case of the tractor equipped
with the cold start system, do
not use starting uid.
•
Make sure to reduce the engine rpm
with the hand throttle lever in the
Low speed position before stopping
the engine. Depress the clutch pedal
and put all shift levers in the neutral
position.
And then turn the main switch to the
"OFF" position to stop the engine.
STOPPING ENGINE
1. Reduce the speed when driving
on a bumpy or rough ground.
2. Attach the additional weight need-
ed for stability and safe cornering
if required.
3. Make sure that the front wheels
are not risen up when transport-
ing implements or towing a heavy
load.
TRACTOR OPERATION
WHEN ATTACHING WEIGHT
6015O404A
CAUTION
Do not drive on a road under a
heavily loaded condition. Oth-
erwise, it can lead to an injury
or machine damage.
•
To Next Page
Loading...
