Branson F36r - Control and Operation of Hydraulic System; Scv Control Lever Andcoupler; CONNECTING Cylinder HOSE

5
-
22
Branson F36R(H)/F42R(H)
CAUTION
The hydraulic hoses are subject
to physical wear, aging and ex-
plosion.
Make sure to inspect the hoses
on a regular basis.
If any hose is damaged, replace
it with a new one immediately.
•
•
•
R2 to enable correct operation of the
loader.
CONTROL AND OPERATION OF HYDRAULIC SYSTEM
SCV CONTROL LEVER AND
COUPLER
CONNECTING CYLINDER HOSE
(1) SCV control lever 1
(2) SCV control lever 2
(3) Coupler
The levers (1 and 2) adjust the oil ow
rate and direction of the SVC valves
located on the rear side of the tractor.
The left coupler is for expansion and
the right coupler is for retraction.
1. Distinguish the hoses for expansion
and retraction. The hose for expan-
sion should be connected to the left
coupler while the hose for retrac-
tion should be connected to the right
coupler.
2. Remove the dust cap from the hose
end.
3. Push the coupler cap.
4. Check if the hose end and the cou-
pler are clean. Insert the hose tip
into the coupler correctly. Pull the
hose one time to check that it is
properly inserted.
5. When connecting the outer hydrau-
lic hose, be careful not to allow for-
eign material to enter it. Necessarily
keep the connector clean during in-
stallation.
1
3
2
1
3
2
A42O429B
K3트랙터-유럽향(Branson 36R,42R))-영문-022 22 2016-01-27 오전 10:57:05