6
-
15
MAINTENANCE
6
CHECKING AND ADJUSTING FAN BELT
Loosen the generator mounting bolts
and move the generator to adjust the
tension of the fan belt.
If the fan belt still slips after the gen-
erator is moved to the maximum, re-
place the belt with a new one.
New belts must be inspected after 50
hours of running.
(1) Fan belt
A42O620A
CAUTION
Carry out inspection or mainte-
nance after the engine is fully
cooled down.
If this instruction is ignored, you
may get burnt.
•
Tighten the nuts when the toe-in is
0.2 - 0.3 in. (4 - 8 mm). Be sure of
both lengths of the left and right tie
rod ends are the same.
To Next Page
Loading...
