Branson F36r - Tires, Wheels and Ballast; TIRE Type

5
-
23
OPERATION
5
TIRES, WHEELS AND BALLAST
TIRE TYPE
Though the tire pressure is factory
set to the prescribed level, it naturally
drops slowly in the course of time.
Thus, check it everyday and inflate
as necessary.
(1) Tire (2) Wheel nut
(3) Rim bolt (4) Rim
A42O522A
Specication
Wheel & axle mount
-
ing bolt
167 - 206 N.m
(17 - 21 kgf.m)
Wheel rim and disc
mounting bolt
167 - 206 N.m
(17 - 21 kgf.m)
TIGHTENING TORQUE
PROPER INFLATION PRESSURE
Tire size
Ination
pressure
(Kg/cm
2
)
With ro
-
tary tiller
Front
wheel
7-16/8-16 2.0
Rear
wheel
11.2-24/
12.4-24
1.3
With
loader
Front
wheel
7-16/8-16 3.0
Rear
wheel
11.2-24/
12.4-24
2.0
CAUTION
Escaping hydraulic uid under
pressure has sufcient force to
penetrate skin, causing a seri-
ous personal injury. Be sure to
release all residual pressure be-
fore disconnecting hydraulic
lines. Before adding pressure
to the hydraulic system, make
sure to tighten all connections.
To check leakage, use a card
-
board and protect your hands
and feet from the pressurized
uid.
If injured by escaping uid, see
a medical doctor at once. This
fluid injected in the skin can
produce gangrene and/or se-
vere allergic reaction.
The outer hydraulic pipes are
subject to physical wear, aging
and explosion. Failure to per-
form periodic inspections may
lead to a uid leak. Periodically
inspect the hoses and immedi-
ately replace if required.
•
•
•
•
K3트랙터-유럽향(Branson 36R,42R))-영문-023 23 2016-01-27 오전 10:57:06