Bresser 7003360 - Back Light

23
NOTE:
- When you turn on the time alarm, the " " icon will display on time section.
- When you turn on the weather alert, the "
" icon will display on the top of reading.
- During the setting, press and hold the [ + / WIND ] or [ - / BARO ] key for quick-adjusting the value.
- The alarm function(s) will turn on automatically once you set the alarm time.
- During the setting, you can back to normal mode by press and hold [ SET ] key for 2 seconds.
4.4.2.1 VIEW ALARM TIME AND WEATHER ALERT VALUE
1. In normal mode, press [ ALARM ] key to show the alarm time.
2. When the alarm time displays, press [ ALARM ] key again to show the high alert value.
3. Press [ ALARM ] key again to show the low alert value.
4.4.2.2 ALARM OPERATION
If you set the time alarm, and reach the time that you set, alarm sound will start.
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in the next day.
- By pressing [BACK LIGHT / SNOOZE] key to enter snooze that the alarm will sound again after 5
minutes.
- By pressing and hold [BACK LIGHT / SNOOZE] key for 2 seconds or press [ ALARM ] key to stop the
alarm and will activate again in the next day.
NOTE:
- The snooze could be used continuously in 24 hours.
- During the snooze, the alarm icon "
" will keep ashing.
4.4.2.3 WEATHER ALERT OPERATION
If you set the weather alert, and this value out of the setting range, alarm sound will start and
the related weather reading will ash.
Where it can be stopped by following operation:
- Auto-stop once the value back to the range.
- By pressing the [BACK LIGHT / SNOOZE] or
[ ALARM ] key to stop the sound.
4.4.3 BACK LIGHT
The console back light brightness can be adjust by using the [BACK LIGHT / SNOOZE] key
to toggle between Hi, Lo or O󰀨.