Bresser 7003360 - Calibration and Firmware Updates

28
5.6 CALIBRATION
C
o
C
o
%
%
Default value is 0
Default value is 0
Default value is 0
Default value is 0
Default value is 0
Default value is 0
0
+ 0.1
0
2
Relative Pressure Offset
Absolute Pressure Offset
0
0
hPa
hPa
Wind speed gain
UV gain
Rain gain
Light gain
Temperature
Temperature
Humidity
Humidity
Default value is 1
Default value is 1
Default value is 1
Default value is 1
Indoor
Outdoor
1
1
1
1
Wi-Fi
Calibration
Weather server
Edit device
Firmware
Settings
Confirm & Exit
(a) Settings page
At the settings page, tap "Calibration".
(b) Calibration page
1. Tap "Unit" to change the unit if necessary
before entering the calibration value.
2. Tap the box and enter the calibration
required.
3. Tap "Save".
Calibration Unit
Save
NOTE:
- Calibration of most parameter is not required, with the exception of Relative Pressure, which must be
calibrated to sea-level to account for altitude e󰀨ects.
- For temperature and pressure, the app will always calculate & convert the calibration value in C and hPa
respectively.
5.7 FIRMWARE
Wi-Fi
Calibration
Weather server
Edit device
Firmware
Settings
Confirm & Exit
Firmware
Update
Firmware version
1.00
New Firmware 1.01 available
(a) Settings page
At the settings page, tap
"Firmware".
(b) Your current rmware version will be
shown. Tap "Update" if new rmware is
available (indicated by a red dot)
After rmware uploaded
to console, please check
status on your device,
Please refer to section 8.1
for more detail.