What to do if my Brewer Science Laboratory Equipment system is dead with no display?
If your Brewer Science Laboratory Equipment system is dead and the touch screen isn't displaying anything, the cause may be blown fuses or the machine not being properly plugged in. Try replacing the fuse or plugging in the machine and connecting the power.
What to do if my Brewer Science Laboratory Equipment shows a spin vacuum error?
If you're getting a spin vacuum error on your Brewer Science Laboratory Equipment, it could be due to vacuum loss during the spin process or a worn-out spindle vacuum seal. Check the utility connections and verify that the incoming vacuum is more than 25 in Hg.
What to do if my Brewer Science Laboratory Equipment process runs without speed change?
If your Brewer Science Laboratory Equipment process runs without a speed change, this may be due to a servo motion error. Try cycling the power on the machine. If the error happens again, change the speed or acceleration parameters and try again.
Why does my Brewer Science Cee 200X Laboratory Equipment make a grinding sound?
The grinding sound in your Brewer Science Laboratory Equipment indicates that the bearings are likely failing.
What to do if my Brewer Science Laboratory Equipment lid close error?
If your Brewer Science Laboratory Equipment displays a lid close error, it might be because the lid isn't fully closed or it opened during the spin process. Make sure to close the lid before spinning the substrate.
Why is my Brewer Science Cee 200X Laboratory Equipment vibrating?
Vibration in your Brewer Science Laboratory Equipment could be due to a loose belt or mechanical damage.
Why is my Brewer Science Cee 200X Laboratory Equipment oscillating?
Oscillation in your Brewer Science Laboratory Equipment is likely due to a loose belt.
General| Brand | Brewer Science |
|---|---|
| Model | Cee 200X |
| Category | Laboratory Equipment |
| Language | English |
To Next Page