This machine uses compressed gases that can provide motive force to
components and
can expand violently upon decompression. Disconnect
N
2
or clean dry air (CDA) before removing any panels.
This machine has components capable of very-high-speed rotation.
Ensure all lids and panels are in place before activating the rotational
features.
Ensure that all panels are on and in their correct locations before
powering up or operating the machine.
When opening the lid, be aware of the pinch point at the hinge cover.
Open the lid only by
using the handle on the lid.
The unit is very heavy, and proper precautions should be taken when
handling or moving the
machine to minimize risk of injury.
Always wear the proper personal protective equipment (PPE) for the job,
including safety
glasses, gloves, and other equipment as needed to
protect from mechanical and chemical hazards.
Ensure all chemicals and materials being used in the
tool are chemically
compatible with the systems they will come in contact with during use.
Consider all wetted parts of the storage, supply, dispense, and waste
systems.
Ensure the chemical compatibility of all chemicals with each other. All
dispensed materials
are held in one common waste storage tank. Before
use, check for the potential for reactions between chemicals.
Flammable chemicals. No open flames/sparks.
Relieve pressure before opening canisters, tanks, cartridges, or syringes
to refill.
Relieve pressure and shut off chemical valves before removing spin lid
or changing backside rinse (BSR) tubes, edge bead removal (EBR)
tubes, or any other dispense nozzle or spray tip.
To Next Page
Loading...