Brewer Science Cee 200X - 4 Spin Coater Overview; Model and Revisions; System Specifications; Safety Hazards;Precautions

8
4. Spin Coater Overview
4.1 Model and Revisions
The model and serial number information for the Cee
®
200X spin coater is located on
the rear panel near the power inlet. Software version information can be found on the
main software screen. See section 5, Software, for screen shots and a detailed
explanation of the system software.
4.2 System Specifications
Maximum spin speed
6,000 or 12,000 or 16,000 rpm
(depending on option purchased)
Maximum ramp
30,000 rpm/s
Speed accuracy
< 0.2 rpm
Maximum substrate size
accommodated by bowl
200 mm
Recipe storage
Virtually unlimited
Power
100-120 or 220 volts AC, single phase
Weight
40 lb
4.3 Safety Hazards/Precautions
Read this manual in its entirety before operating the machine.
4.3.1 Overview of Equipment-Specific Hazards
The unit is very heavy and proper precautions should be taken when handling the
machine to minimize risk of injury. Labels are placed on the machine to identify areas
where caution is needed during operation.
4.3.2 Electrical
General Hazard
Pinch Point Warning
Notes:
High voltage is present in the machine. Disconnect the power before
servicing.
Stored electrical energy is present in the machine. Before servicing,
allow sufficient time for discharge. The servo amp has a charge light; do
not service the machine until this light has gone out.