Broaster 1800GH - Cover and Yoke Tips; Pressure System Tips

10-4
COVER AND YOKE TIPS
PRESSURE SYSTEM TIPS
DO NOT attempt to tighten, repair or replace any fitting, line or compo-
nent when there is pressure in the cooking well. Hot oil could spray out
under pressure causing serious burns.
COMPLAINT CAUSE REMEDY
Cover hard to CLOSE
1. O-ring dry or dirty
2. O-ring groove dirty
3. Hard O-ring
1. Clean and lubricate
2. Clean
3. Replace
Cover won’t OPEN
Never use force to OPEN
cover.
1. O-ring dry or dirty
2. O-ring groove dirty
3. Hard O-ring
4. Pressure not released
5. Pressure regulating valve
out of adjustment
1. Clean and lubricate
2. Clean
3. Replace
4. OPEN pressure regulating
valve
5. Contact service person
O-ring Break
DO NOT rest basket on
top flange of cooking well.
Damage to area in con-
tact with o-ring can cause
leaking under pressure or
0-ring failure.
1. O-ring groove dirty
2. Nicks in cooking well or
cover
1. Clean
2. Remove
Pressure Gauge does not
indicate rising pressure
when exhaust valve is
closed.
1. Port is plugged
2. Pressure gauge is dam-
aged
1. Clean port on bottom of
cover
2. Replace pressure gauge
COMPLAINT CAUSE REMEDY
No pressure
1. Pressure regulating valve
OPEN
2. Pressure regulating valve
dirty or blocked open
3. Leaks around cover O-
ring
1. CLOSE
2. Contact service person
3. Replace O-ring
Excess pressure
1. Turn power switch OFF.
Contact service person.
broaster.com Manual #17270 10/13 Rev 12/14