Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 1
53-1002965-01
Chapter
1
Using Diagnostic Commands
This chapter contains the following sections:
•Using debug commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
•Generic debug commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Using debug commands
This section describes how to use debug commands to monitor and troubleshoot Brocade FCX,
Brocade ICX, and Brocade TurboIron switch configurations. The debug commands are accessible
from the Privileged EXEC mode in the IronWare command line interface (CLI). Most of the debug
commands can be configured to send output to a specified destination.
When enabled, the debug commands can noticeably affect system performance. Many debug
commands are specifically designed to be used in conjunction with calls to Brocade technical
support. If you report a problem, the support engineer may ask you to execute one or more of the
debug commands described in this guide.
Some debug commands report information about internal hardware settings and registers, which is
relevant primarily to the Brocade engineering staff. These commands are not described in this
document.
Brief and detail debug options
When enabled, many debug commands can significantly impact system performance. Many debug
commands provide options for brief or detailed reporting. Generating detailed output places an
additional burden on system performance, and in many cases the results may be more difficult to
interpret than output generated using the brief option. To conserve performance and prevent
system disruption, use the brief option whenever possible.
Generic debug commands
The following generic debug commands perform functions related to all debugging actions:
• debug ?—Generates a list of debug options.
• [no] debug all—Enables or disables all debug functions.
• show debug—Shows all enabled debug settings.
• debug destination—Allows you to select an output destination; Telnet, SSH, console, or logging
(default).
To Next Page
Loading...
Need help?
General
